Gray Water: A Precious Resource

first_imgEver wonder why we habitually waste so precious a resource as water? We seem to be more conscious of wasted electricity than water going down the drain. Maybe it’s because of the speed of the dial going around in the meter.Wasted water is a loss in at least three ways. First, the direct cost of the resource itself. In addition, most utility companies charge a sewer fee based on the amount of water used. And there is a cost to get the water to your home. Water pressure to deliver the 40 psi pressure (minimum required by the International Residential Code) comes from pumps that consume energy in the form of electricity or fossil fuel at various pumping stations along the way to your home. We spend 56 billion kWh delivering potable water to our taps every year. That’s enough to power all the electricity for 43,000 homes!Each person in the United States uses about 100 gallons of water every day. We only drink about 1% of that. Much of the remaining water is used to facilitate sewage disposal or landscaping. Toilets represent a significant demand for water. Older toilets use several gallons per flush. A green home must be one that makes efficient use of all water.Imagine using some of the water that would otherwise go down the drain a second time. This is called gray water— domestic wastewater that has been used at least once and is effectively recycled for additional use. It may not be potable, but it can serve to flush toilets or irrigate the yard. Gray water is traditionally drawn from lavatories, bathtubs, showers, laundry trays, or clothes washer that have lighter impurities, such as soap or skin residue. It serves the toilet’s needs, and at no additional cost! Use of gray water as illustrated at right would be diverted to a tank and either fed to landscaping or retained until needed for flushing.But, you may ask, is it approved? Appendix O of the IRC sets out prescriptive standards for gray water systems. There are even schematic illustrations that provide the novice with sufficient detail to install one. Appendix O may serve as an option for you to install in lieu of traditional sewer routing and for landscaping. These provisions are optional for each jurisdiction to adopt or not. For it to be legally available to you it must be adopted as part of the building code. In any case, you could take advantage of this provision through the use of Section R104.11 of the IRC, “Alternative Materials and Methods of Construction.”Materials for the system are the same as for drain, waste, and vent piping. They must be inspected in the same manner as well. Any connection between gray water systems and the potable water system must ensure adequate protection to avoid cross connection. The gray water must pass through a filter such as media, sand, or dichotomous earth filter. A full open valve must be installed downstream of the last fixture to allow for maintenance and repair of the system. The holding tank or reservoir must be durable, nonabsorbent, corrosion resistant, and gas-tight.For inspection and maintenance purposes, access panels are required on the tank. The collection reservoir must have an overflow pipe at least as large as the influent pipe. The drain pipe must be the same size as the overflow pipe. The drain must be on the lowest point of the reservoir and indirectly connected to the sanitary drainage system. The reservoir must have a vent to allow proper drainage and to prevent syphonage. Where gray water is used for flushing toilets, a disinfectant such as chlorine, iodine or even ozone must be used.There are several other requirements for both flushing and landscape irrigation so be sure and ask your local building official.last_img

Leave a Reply

Your email address will not be published. Required fields are marked *